FAN 50 PLUS PINS 80-8673

$134.95

80-8673 The FAN 50 Plus Pins is designed to replace the new Suburban® Fan Control boards and the Atwood® / HydroFlame® Fan Control boards as well as the Dinosaur Fan Control boards which have been available since 1994. This board can also be used to upgrade older furnaces to add the Fan Control feature. The basic purpose of a Fan Control Ignitor Board is to shut the fan motor off if the board fails to sense a flame after the third ignition try. Thus, battery drain is reduced and the needless blowing of cold air is eliminated. The FAN 50 Plus Pins , after shutting the fanmotor off, will wait for 1 hour and repeat the whole sequence again before permanent shut down. For 12 VDC Furnaces ONLY! The "Fan Control" feature MUST BE USED for proper operation of this board.


Add to Cart:

  • Model: FAN 50 PLUS PINS
  • Shipping Weight: 1lbs
  • 3 Units in Stock
  • Manufactured by: Circuit Boards



This product was added to our catalog on Friday 07 September, 2007.

Customers who bought this product also purchased...


Copyright © 2017 Out-of-Doors Mart. Powered by Zen Cart